Table of Contents
Advertisement
Rexroth Frequency Converter EFC x610
Series
12.1.3 Parameter Copy
This function is used to copy parameter settings between multiple frequency
converters via the operating panel. Parameters can be stored on the panel of the
frequency converter, after the panel is plugged into a different converter the
same settings can be copied to this converter.
Code
Name
b0.11 Parameter copy
Setting range of b0.11:
0: Inactive
●
This parameter will be reset to 0 automatically after parameter copy is finish-
ed.
1: Backup parameters to panel
●
All customer parameter settings are copied to the panel.
2: Restore parameters from panel
●
All customer parameters settings are restored from the panel.
The following parameters are not included in parameter copy function:
Read only parameters(d0 group, F0 group, C0.51, E9.05...E9.99, U0.99,
●
H0.01, H0.02, H0.03, H0.18, H0.19, H0.20, H0.30, H0.23, H0.33, H1.01,
H1.02)
Panel parameters(U1 group, U2 group)
●
Auto reset after execution parameters(b0.09, b0.10, b0.11, b0.20, b0.21,
●
C0.53, C1.01)
Real time data parameters(E2.20, E2.28, H0.00, H0.10, H0.12, H0.14, H0.15,
●
H0.16, H0.50, H8.23, H8.28)
MEP card parameters(H3 group, H4 group)
●
Diagnosis parameters(H8.87, H9.97)
●
All other operations will be inactive during parameter replication. The panel
can't be operated, data can't be accessed with engineering tools or fieldbus un-
til the operation is finished.
When a parameter restore is started, all the parameters on the device will be set
to the initial values first, this ensures a compatible behavior also over different
firmware versions.
The state of progress during the operation is shown in the panel as below:
Setting range
0...2
R912005854_Edition 09 Bosch Rexroth AG
Functions and Parameters
Default
Unit
Step
0
–
121/653
Attri.
–
Stop
Advertisement
Table of Contents
