Rexroth Frequency Converter EFC x610
Series
Push-pull Pulse Output Wiring
Encoder power supply
Source option
External
External
Tab. 15-9:
1. Please make sure that the power supply has been switched off
before wiring.
2. Please check input pulse voltage of PLC before power on.
3. Using shielded twisted-pair cable as output signal cable.
4. Signal cable shield should be connected to the PE terminal of
encoder card.
Fig. 15-30:
Fig. 15-31:
Cable Length
Cable length (m)
Voltage
24 V
24 V
AWG
R912005854_Edition 09 Bosch Rexroth AG
Output
Pull up
Pull down
Cable cross
531/653
Accessories
Reference
Wiring 10
Wiring 11
mm
2