Bosch rexroth EFC 610 Series Operating Instructions Manual page 434

400/653
Functions and Parameters
Bit Name
17 FW CRC-OK
16...15 -
14 PDC Invalid
13 PDC Difference
12 Connection Timeout
11 Connection Closed
10 Connection Idle
9 Connection Error
8 Fieldbus Initiate Error
7...6 -
5 Identify Error
4 DHCP Error
3 MAC Address Error
2 IP Initiate Error
1 IP Address Error
0 Link Error
Tab. 12-124: Parameter H3.35
H3.36 MEP: ComCycle Periods [ns]
●
This parameter consists of three values that define current communication cy-
cle periods. All values are given in nanoseconds.
– Value 1: Transmission Cycle On Bus
– Value 2: Producer Cycle (Input Data Cycle)
– Value 3: Consumer Cycle (Output Data Cycle)
Bosch Rexroth AG R912005854_Edition 09
Rexroth Frequency Converter EFC x610
Communication Platform Firmware consistency check done
and status is OK.
Reserved
Process Data Configuration contains unknown/unsupported
parameters or exceeds maximum data length of 15 parame-
ters for input and output data, each.
Process Data Configuration of Communication Platform
([H3.30]/[H3.31]) and Process Data Configuration of Field-
bus Master are differing in data length.
An existing cyclic communication was terminated because of
missing master telegrams.
An existing cyclic communication was closed by the fieldbus
master.
Fieldbus master set process data status to "invalid".
An existing cyclic communication got broken because of a
communication problem.
Error while starting fieldbus stack
Reserved
Invalid identification parameters
DHCP request: No response from DHCP server.
Invalid MAC address
Error while starting IP stack
IP address already present at subnet
No Ethernet link
Description
Series