Show Spanning-Tree Mst Port Detailed - NETGEAR ProSafe GSM7248 User Manual
Layer 2 managed switch software version 4
Hide thumbs
Also See for ProSafe GSM7248:
- Operating instructions manual (22 pages) ,
- Brochure (2 pages) ,
- Cli reference manual (284 pages)
Table of Contents
Advertisement
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Port Up Time Since Counters Last Cleared
STP BPDUs Transmitted
STP BPDUs Received
RST BPDUs Transmitted
RST BPDUs Received
MSTP BPDUs Transmitted
MSTP BPDUs Received
show spanning-tree mst port detailed
This command displays the detailed settings and parameters for a specific switch port within a
particular multiple spanning tree instance. The instance <mstid> is a number that corresponds to
the desired existing multiple spanning tree instance. The <slot/port> is the desired switch port.
Format
Mode
MST Instance ID
Port Identifier
Port Priority
Port Forwarding State
Port Role
Auto-Calculate Port Path Cost
Port Path Cost
8-130
minutes, and seconds.
Spanning Tree Protocol Bridge Protocol Data Units sent
Spanning Tree Protocol Bridge Protocol Data Units received.
Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
Rapid Spanning Tree Protocol Bridge Protocol Data Units received.
Multiple Spanning Tree Protocol Bridge Protocol Data Units sent
Multiple Spanning Tree Protocol Bridge Protocol Data Units received.
show spanning-tree mst port detailed <mstid> <slot/
port>
Privileged EXEC
User EXEC
The ID of the existing MST instance.
The port identifier for the specified port within the selected MST
instance. It is made up from the port priority and the interface number of
the port.
The priority for a particular port within the selected MST instance. The port pri-
ority is displayed in multiples of 16.
Current spanning tree state of this port.
Each MST Bridge Port that is enabled is assigned a Port Role for each
spanning tree. The port role is one of the following values: Root Port,
Designated Port, Alternate Port, Backup Port, Master Port or Disabled
Port
This indicates whether auto calculation for port path cost is
enabled.
Configured value of the Internal Port Path Cost parameter.
202-10102-01, May 2005
Time since port was reset, displayed in days, hours,
Switching Commands
Advertisement
Table of Contents
