Rep 5.1.7: Speaker Assembly - Xerox 450c Service Manual

REP 5.1.7: Speaker assembly

Parts List: 3.1
1. Perform the following:
a. REP 1.1: WorkCentre Cover on page 4-3
2. Disconnect the speaker wiring harness from
connector J2 on the analog board.
3. Use your thumb to push out the speaker
retaining clips until you can remove the
speaker from the slot (Figure 4-49).
Speaker retaining tab
Figure 4-49 Speaker assembly
4. Remove the speaker cushion.
Page 4-44
www.printcopy.info
Xerox WorkCentre 450c/450cp Service Manual