Advanced Errors; Error Acknowledgment; Table 49 Advanced Errors; Figure 41 Error Acknowledgment - WAGO 750 Product Manual

750-1632/000-100

7.3.3 Advanced Errors

Error
Code
9
16
1046
1047
1048
2007
2008

7.4 Error Acknowledgment

The "Status, Channel 1"/"Status, Channel 2" and "Module Error" LEDs light up red. The
READY status bit is set to "0." Status bits 0 (module error), 1 (collective error for chan-
nel 1), 2 (collective error for channel 2) and 6 (collective error) of the local bus are set
to "1." Once the cause of the error is eliminated, the error message can be reset by a
negative edge of the Vx_CTRL_STATUS.PWR_EN bit. The following figure illustrates the
behavior:
Product manual | Version: 1.1.0
Proportional Valve Module 2-3-4
Chan- Event Qualifier
nel
Mode Type
No.
128 APPDIS ERROR Internal error
128 SINGLE ERROR ParamChn_Error
128 SINGLE ERROR Internal input buffer full.
128 SINGLE ERROR Internal output buffer 1 full.
128 SINGLE ERROR Internal output buffer 2 full.
128 SINGLE ERROR CmdInterf_Error
128 SINGLE ERROR RegCom_Error
Cause of Error
Send error report to WAGO Sup-
port
GSD check
Send error report to WAGO Sup-
port
Send error report to WAGO Sup-
port
Send error report to WAGO Sup-
port
Send error report to WAGO Sup-
port
Send error report to WAGO Sup-
port
Figure 41: Error Acknowledgment
Diagnostics
Table 49: Advanced Errors
Corrective Action
73