Active System" Page; Table 83: Wbm "Active System" Page - "Boot Device" Group; Table 84: Wbm "Active System" Page - "System <N> (Internal Flash)" Group - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100

15.1.1.2.10 "Active System" Page

The settings for specifying the partition from which the system is started are
shown on the "Active System" page.
"Boot Device" Group
Table 83: WBM "Active System" Page – "Boot Device" Group
Parameter
Boot Device
"System <n> (Internal Flash)" Groups
Table 84: WBM "Active System" Page – "System <n> (Internal Flash)" Group
Parameter
Active
Configured
State
Click the respective [Activate] button to start the required system at the next
reboot.
Provide a bootable system!
A functional firmware backup must be available on the boot system!
Explanation
The storage medium from which the device was
booted is displayed here.
Explanation
This shows whether the system is active.
This shows whether the system should be active
after the next reboot.
The system status is displayed here.
good The system is valid and can be used.
The system is not valid and cannot be
bad
used.
Version 1.1.0, valid from FW Version 03.08.07(20)
Appendix 155
Manual