RIGOL
2 Command System
:WAVeform Commands
The :WAVeform commands are used to read the waveform data and its related settings.
The
:WAVeform:MODE
command is used to set the reading mode of the waveform data. In different
mode, the definition of each parameter is different, as shown in Figure 2-1 and Figure 2-2.
XORigion
XINCrement=TimeScale/100
XREFerence
YORigion
YREFerence
YINCrement=Verticalscale/25
Figure 2-1 Parameter Definitions in NORMAL Mode
XREFerence
XORigion
XINCrement=1/SampleRate
YORigion
YREFerence
YINCrement=Vscale/25
Figure 2-2 Paramter Definitions in RAW Mode
2-329
MSO2000A/DS2000A Programming Guide