Waveform Commands - Rigol DS1000Z Series Programming Manual

Chapter 2 Command System

:WAVeform Commands

The :WAVeform commands are used to read the waveform data and its related settings.
is used to set the reading mode of the waveform data. In different mode, the definition of each parameter
is different, as shown in Figure 2-1 and Figure 2-2.
XINCrement=TimeScale/100
YINCrement=Verticalscale/25
XINCrement=1/SampleRate
DS1000Z Programming Guide
XREFerence
YORigion
YREFerence
Figure 2-1 Parameter Definitions in NORMAL Mode
XORigion
XREFerence
YORigion
YREFerence
YINCrement=Vscale/2
Figure 2-2 Paramter Definitions in RAW Mode
XORigion
RIGOL
:WAVeform:MODE
2-133