Rigol MSO2000A Series Programming Manual page 253

2 Command System
SINusoid: sine
SQUare: square
USER: arbitrary waveform
<freq>: set the frequency of the specified waveform (noise does not have this parameter). The

default unit is Hz.
<amp>: set the amplitude of the specified waveform. The default unit is Vpp.
<offset>: set the DC offset of the specified waveform. The default unit is VDC.
<phase>: set the start phase of the specified waveform (noise does not have this parameter). The
default unit is degree (°).
One or more parameters can be omitted for these commands. When all the parameters are omitted,

these commands only configure the specified signal source channel to the specified waveform and
do not modify the corresponding parameters.
<freq>, <amp>, <offset> and <phase> are placed in order. You cannot omit the one parameter and

directly set the parameters behind it. For example, you cannot omit <freq> and directly set <amp>.
The ranges of <amp> and <offset> are related to the output impedance of the signal source

channel. You can use the
signal source.
Example
:APPLy:NOISe
:APPLy:PULSe 100,1,0.5
:SOURce2:APPLy:SINusoid 100,1,0.5,0 /*Set Source2 to output a sine with 100Hz frequency, 1Vpp
MSO2000A/DS2000A Programming Guide
:OUTPut[<n>]:IMPedance
/*Set the waveform of Source1 to noise and do not modify the
parameters*/
/*Set Source1 to output a pulse with 100Hz frequency, 1Vpp
amplitude and 500mVDC offset*/
amplitude, 500mVDC offset and 0° start phase*/
command to set the output impedance of the
RIGOL
2-237