Source<N> Commands (Mso2000A-S/Ds2000A-S) - Rigol MSO2000A Series Programming Manual

2 Command System
:SOURce<n> Commands (MSO2000A-S/DS2000A-S)
The [:SOURce<n>] commands are used to set the output waveforms and their parameters of the built-in
signal source of the oscilloscope. <n> is the number of the channel (1 or 2) and the operation will be
executed on Source1 by default if [:SOURce<n>] is omitted.
[:SOURce<n>]:FREQuency[:FIXed]

[:SOURce<n>]:PHASe[:ADJust]

[:SOURce<n>]:PHASe:INITiate

[:SOURce<n>]:FUNCtion[:SHAPe]

[:SOURce<n>]:FUNCtion:RAMP:SYMMetry

[:SOURce<n>]:VOLTage[:LEVel][:IMMediate][:AMPLitude]

[:SOURce<n>]:VOLTage[:LEVel][:IMMediate]:OFFSet

[:SOURce<n>]:PULSe:DCYCle

[:SOURce<n>]:MOD[:STATe]

[:SOURce<n>]:MOD:TYPe

[:SOURce<n>]:MOD:AM[:DEPTh]

[:SOURce<n>]:MOD:AM:INTernal:FREQuency

[:SOURce<n>]:MOD:AM:INTernal:FUNCtion

[:SOURce<n>]:MOD:FM[:DEVIation]

[:SOURce<n>]:MOD:FM:INTernal:FREQuency

[:SOURce<n>]:MOD:FM:INTernal:FUNCtion

[:SOURce<n>]:APPLy:NOISe

[:SOURce<n>]:APPLy:PULSe

[:SOURce<n>]:APPLy:RAMP

[:SOURce<n>]:APPLy:SINusoid

[:SOURce<n>]:APPLy:SQUare

[:SOURce<n>]:APPLy:USER

[:SOURce<n>]:APPLy?

MSO2000A/DS2000A Programming Guide
RIGOL
2-223