RIGOL
:WAVeform Commands
The :WAVeform commands are used to read waveform data and relevant settings.
command is used to set the reading mode of waveform data. In different modes, the definitions for the
parameters are different, as shown in Figure 2-1 and 2-2.
XINCrement=TimeScale/100
YORigion
YREFerence
YINCrement = VerticalScale/25
XINCrement = 1/SampleRate
YORigion
YREFerence
YINCrement
[1]
Note
: In RAW mode, YINCrement and Verticalscale of the memory waveforms are related to the currently selected
Verticalscale.
Command List:
:WAVeform:SOURce
2-224
XREFerence
Figure 2-1 Parameter Definitions in NORMAL Mode
XREFerence
[1]
Figure 2-2 Parameter Definitions in RAW Mode
XORigion
XORigion
MSO7000/DS7000 Programming Guide
Chapter 2 Command System
The:WAVeform:MODE