2 Command System
:SINGle
Syntax
:SINGle
Description
Set the oscilloscope to single trigger mode.
Explanation
In single trigger mode, the oscilloscope triggers once the trigger conditions are met and then stops.
In single trigger mode, using the
You can use the
:RUN
state respectively.
:TFORce
Syntax
:TFORce
Description
Generate a trigger signal forcefully. The function of this command is the same as that of FORCE in the
trigger control area at the front panel.
:TLHAlf
Syntax
:TLHAlf
Description
Set the trigger level to the vertical midpoint of the trigger signal amplitude.
MSO2000A/DS2000A Programming Guide
:TFORce
command can generate a trigger signal forcefully.
and
:STOP
command to set the oscilloscope to Auto trigger mode and STOP
RIGOL
2-3