Autoscale; Clear; Run; Stop - Rigol MSO2000A Series Programming Manual

RIGOL

:AUToscale

Syntax
:AUToscale
Description
Enable the waveform auto setting function. The oscilloscope adjusts the vertical scale, horizontal time
base and trigger mode according to the input signal automatically to realize optimum waveform display.
The function of this command is the same with that of AUTO at the front panel.
Explanation
This command is invalid when the AUTO function is disabled. For the details, please refer

to :SYSTem:AUToscale.
When the current status of the pass/fail function is "Enable Test", this command is not available. For

the details, please refer to :MASK:ENABle.

:CLEar

Syntax
:CLEar
Description
Clear all the waveforms on the screen. New waveforms will still be displayed if the oscilloscope is in RUN
state. The function of this command is the same with that of CLEAR at the front panel.

:RUN

:STOP

Syntax
:RUN
:STOP
Description
The :RUN command starts the oscilloscope and the :STOP command stops the oscilloscope. The functions
of these commands are the same with those of RUN/STOP at the front panel.
Explanation
These commands are invalid when waveform recording or waveform playback is turned on.
2-2
2 Command System
MSO2000A/DS2000A Programming Guide