Installing Crop Dividers With Latch Option Onto Header - MacDon D65 Operator's Manual

3. Remove bolt (A), lock washer, and flat washer.
4. Lower crop divider (B) and then lift to remove
from endsheet.
5. Close or install endshields. Refer to
page 35.

Installing Crop Dividers with Latch Option onto Header

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel, raise header, stop engine, remove key, and engage safety props. For instructions, refer to your
windrower operator's manual.
2. Open or remove endshields. Refer to
3. Remove crop divider from storage location by lifting
crop divider to disengage lugs (A) at lower end
and then lowering it slightly to disengage pin (B)
from endsheet.
147725
OPERATION
3.2.3 Endshields,
Figure 3.50: Crop Divider
3.2.3 Endshields, page
Figure 3.51: Stored Crop Divider
69
35.
Revision A