MacDon D65 Operator's Manual page 139

1. Wipe grease fitting with a clean cloth before greasing
to avoid injecting dirt and grit.
2. Inject grease through fitting with grease gun until
grease overflows fitting (except where noted).
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose or broken fittings immediately.
5. Remove and thoroughly clean any fitting that will
not take grease. Also clean lubricant passageway.
Replace fitting if necessary.
6. Use clean, high temperature extreme pressure
grease only.
147725
MAINTENANCE AND SERVICING
Figure 5.13: Single-Knife Header Master Grease
Point Decal
Figure 5.14: Double-Knife HeaderMaster Grease
Point Decal
125
Revision A