Tine Tube Bushings; Removing Bushings From Five-, Six- Or Nine-Bat Reels - MacDon D65 Operator's Manual

IMPORTANT:
Do NOT apply force to finger prior to tightening
mounting screw. Applying force to finger without screw
tightened will break finger or shear off locating pins.
3. Install screw (A) and torque to 75–80 in·lbf
(8.5–9.0 N·m) with a Torx

5.8.5 Tine Tube Bushings

Removing Bushings from Five-, Six- or Nine-Bat Reels

WARNING
To avoid bodily injury from fall of raised reel, always engage reel safety props before going under raised
reel for any reason.
NOTE:
If only replacing the cam end bushing, refer to Cam End Bushings.
Center Disc and Tail-End Bushings
1. Lower header, raise reel fully, and engage reel safety props.
IMPORTANT:
Ensure tine tube is supported at all times to prevent damage to the tube or other components.
2. Remove reel endshields and endshield support (C)
from the tail end of the reel at applicable tine
tube location.
NOTE:
There are no endshields on the center disc.
3. Remove bolts (A) securing arm (B) to disc.
IMPORTANT:
Note the hole locations in arm and disc and
ensure bolts are reinstalled at original locations.
147725
MAINTENANCE AND SERVICING
®
-Plus 27 IP socket wrench.
Figure 5.157: Plastic Fingers
Figure 5.158: Tail End
194
Revision A