Repositioning Fore-Aft Cylinders On Double Reel - MacDon D65 Operator's Manual

Repositioning Fore-Aft Cylinders on Double Reel

The reel can be moved approximately 9 in. (227 mm) further aft by repositioning the fore-aft cylinders on
the reel arms.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
Reposition the center arm cylinder as follows:
NOTE:
Reel components not shown in illustration for
improved clarity.
1. Position reel fully aft with support arms horizontal.
2. Stop engine and remove key.
3. Remove four bolts (A) securing cylinder bracket (B) to
reel arm.
4. Push/pull reel until bracket (B) lines up with the fore/aft
set of holes (C).
5. Reinstall four bolts (A) to secure bracket (B) to reel arm
at new position.
147725
OPERATION
Figure 3.36: Forward Position
Figure 3.37: Rearward Position
62
Revision A