Shifting Decks Manually - MacDon D65 Operator's Manual

3.9.2 Shifting Decks Manually

Both decks can be moved manually to deliver the crop from the center or right/left end on 25- to 40-ft. headers.
To deliver crop from the right end, move the decks to the left end of the header as follows:
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Loosen bolt (A) on the right deck.
2. Slide deck to close off the center opening. Retighten
bolt (A).
3. Reverse the draper drive motor hoses (A) on the
moved deck so that the draper turns the same direction
as the existing deck.
NOTE:
Loosen clamp on plastic sleeve at drive motor so
that hoses (A) can be reversed. Retighten clamp.
NOTE:
To deliver crop from the left end, move the decks to
the right end of the header following the steps above.
147725
OPERATION
Figure 3.63: Right Deck Shown
Figure 3.64: Right Deck Motor
77
Revision A