MacDon D65 Operator's Manual page 113

10. Lock the wheel (A) with pin (B). Move the right axle (C)
to the front of the header.
11. Remove the pin (A), raise support (B) to the position
shown, and reinsert pin.
IMPORTANT:
Ensure the pin (A) engages the tube on the axle.
12. Swing the brace (C) into the position shown and
insert the brace into the slot (D) behind the cutterbar.
Position the brace so that pin (E) engages the hole
in the bracket (F). The right hand wheel is now in
transport position.
13. Disengage the header cylinder lift stops.
14. Detach the header's
connections from the windrower. Refer to
Attachment/Detachment, page
15. Start the windrower and lower the header to
the ground.
147725
OPERATION
hydraulic and electrical
4 Header
105.
Figure 3.93: Right Rear Wheel
Figure 3.94: Right Rear Wheel Position
99
Revision A