Maintenance
Action:
Record
250 Hours or Annually
Draper seal
Upper cross auger center
support and U-joint
Reel drive U-joint
Transport axle pivot
bushings
500 Hours or Annually
Draper seal
Reel shaft bearings
Stabilizer/slow speed
transport wheel bearings
1000 Hours or 3 Years
▲ Knife drive box lubricant
5.3.2 Break-In Inspection
Break-in inspections involve checking belts, fluids, and performing general machine inspections for loose hardware
or other areas of concern. Break-in inspections ensure that all components can operate for an extended period
without requiring service or replacement.
Timing
Item
Check for loose hardware.
Tighten to required torque.
At 5 hours
Check knife drive belts tension.
Periodically check for first 50 hours.
At 10 hours
Check knife drive box mounting bolts.
At 50 hours
Change knife drive box lubricant.
147725
MAINTENANCE AND SERVICING
- Check
11
11
11
- Lubricate
Refer To
8.2 Torque Specifications, page 254
Tensioning Timed Knife Drive Belts, page 155
Tensioning Non-Timed Knife Drive Belts, page 150
Checking Mounting Bolts, page 140
Changing Oil in Knife Drive Box, page 148
116
▲ - Change
Revision A