Installing A Sealed Bearing - MacDon D65 Operator's Manual

5.2.3 Installing a Sealed Bearing

To install a sealed bearing, follow these steps:
1. Clean shaft and coat with rust preventative.
2. Install flangette (A), bearing (B), second flangette (C),
and lock collar (D).
NOTE:
The locking cam is only on one side of the bearing.
3. Install (but do NOT tighten) flangette bolts (E).
4. When the shaft is correctly located, lock the lock collar
with a punch. The collar should be locked in the same
direction the shaft rotates. Tighten the setscrew in
the collar.
5. Tighten flangette bolts.
6. Loosen flangette bolts on mating bearing one turn and
retighten. This will allow the bearing to line up.
147725
MAINTENANCE AND SERVICING
Figure 5.2: Sealed Bearing
113
Revision A