Removing Crop Dividers From Header Without Latch Option; Installing Crop Dividers On Header With Latch Option - MacDon D65 Operator's Manual

Removing Crop Dividers from Header without Latch Option

To remove crop dividers from a header without the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. See your windrower
operator's manual for instructions for use and storage of header safety props.
1. Raise header, stop engine, remove key, and engage
safety props. For instructions, see your windrower
operator's manual.
2. Open/remove header endshield. Refer to Section
Endshields, page 37.
3. Remove bolt (A), lock washer and flat washer.
4. Lower divider (B) and lift off endsheet.
5. Close/replace header endshield. See Section
Endshields, page 37.

Installing Crop Dividers on Header with Latch Option

To install crop dividers on a header with the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. See your windrower
operator's manual for instructions for use and storage of header safety props.
1. Raise header, stop engine, remove key, and engage
safety props. For instructions, see the windrower
operator's manual.
2. Open header endshield.
169594
OPERATION
4.2.3
4.2.3
Figure 4.51
70
Rev. C