Installing Reel Drive Motor - MacDon D65 Operator's Manual

Installing Reel Drive Motor

1. Slide the motor mount (A) up or down so the motor
mounting holes (B) are accessible through the
openings in the chain case.
2. Attach the motor (A) (and spacer if previously removed)
to the motor mount (B) with four 1/2 in. x 1-3/4 in.
countersunk bolts and nuts (C).
3. Torque nuts (C) to 54 lbf·ft (73 N·m).
4. Install the hydraulic fittings (not shown) if installing
new motor, and torque to 81–89 ft·lbf (110–120 N·m).
5. Remove the caps or plugs from the ports and lines
and connect the hydraulic lines (A) to the hydraulic
fittings (B) on the motor (C).
NOTE:
Ensure the hydraulic lines (A) are installed at their
original locations.
6. Install the drive sprocket, refer to
Sprocket, page 214.
7. Tighten the drive chain, refer to
page 212.
147725
MAINTENANCE AND SERVICING
Installing Drive
Tightening Drive Chain,
218
Figure 5.217: Reel Drive Motor Mounting Holes
Figure 5.218: Reel Drive Motor
Figure 5.219: Reel Motor and Hoses
Revision A