MacDon D65 Operator's Manual page 215

6. Tighten clamp (A) with modified channel lock pliers (B)
so that finger pressure will NOT move clamp.
IMPORTANT:
Overtightening clamp may result in breakage.
7. Line up tine bar (B) with cam arm and install bolt (A).
Torque bolt to 120 ft·lbf (165 N·m).
8. At the center disc, install the bolts (A) securing arm (B)
to disc.
9. At the tail end, install reel arm (B) and endshield
support (C) from the tail end of the reel at applicable
tine tube location with bolts (A).
NOTE:
There are no endshields on the center discs.
147725
MAINTENANCE AND SERVICING
Figure 5.175: Installing Clamp
Figure 5.176: Cam End
Figure 5.177: Tail End
201
Revision A