MacDon D65 Operator's Manual page 187

4. Loosen the two lock nuts (A) on the deck support (B)
one-half turn only.
NOTE:
The number of deck supports (B) is determined
by the header size: four on single reels, and
eight on double reels.
5. Tap the deck (C) to lower the deck relative to the deck
supports. Tap the deck support (B) using a punch to
raise the deck relative to the deck supports.
6. Set the deck (A) to a gap (B) of 5/16–3/8 in. (8–9 mm)
below the cutterbar (C) to create a seal.
7. Tighten the deck support hardware (D).
8. Recheck the gap (B) to ensure it is properly set to
5/16–3/8 in. (8–9 mm).
9. Tension the draper. Refer to
Tension, page 165.
10. Adjust the backsheet deflector (A) (if required) by
loosening nut (D) and moving the deflector until there
is a 1/32–5/16 in. (1–7 mm) gap (C) between the
draper (B) and the deflector.
147725
MAINTENANCE AND SERVICING
5.7.3 Adjusting Draper
173
Figure 5.111: Deck Support
Figure 5.112: Deck Support
Figure 5.113: Backsheet Deflector
Revision A