MacDon D65 Operator's Manual page 178

1. Apply talc, baby powder, or talc/graphite lubricant
mix to the draper surface that forms the seal with the
cutterbar and to the underside of the draper guides.
2. Insert the draper into the deck at the outboard end
under the rollers. Pull the draper into the deck while
feeding it at the end.
3. Feed in the draper until it can be wrapped around the
drive roller.
4. Insert the opposite end of the draper into the deck over
the rollers. Pull the draper fully into the deck.
5. Loosen the mounting bolts (B) on the rear deck
deflector (A) (this may help with draper installation).
6. Attach the ends of the draper with tube connectors (B),
screws (A) (with the heads facing the center opening),
and nuts.
7. Adjust the draper tension. Refer to
Draper Tension, page
147725
MAINTENANCE AND SERVICING
5.7.3 Adjusting
165.
Figure 5.90: Installing Draper
Figure 5.91: Draper Seal
Figure 5.92: Draper Connector
164
Revision A