MacDon D65 Operator's Manual page 219

24. Tighten clamp (A) with modified channel lock pliers (B)
so that finger pressure will not move clamp.
IMPORTANT:
Over-tightening clamp may result in breakage.
25. Reattach channels (C) to support (A) with screws (B)
and nuts. Torque screws to 32 ft·lbf (43 N·m).
26. Reinstall any fingers (D) that were removed with
screws (E). Refer to
193.
147725
MAINTENANCE AND SERVICING
Installing Plastic Fingers, page
Figure 5.186: Clamp
Figure 5.187: Support
Figure 5.188: Opposite Support
205
Revision A