9. Pull pin (A) on right-hand wheel, swivel the wheel
counterclockwise to position shown, and lock with
pin (A).
10. Remove the hairpin (B) from the latch (C).
11. Lift the wheel, lift latch (C), and engage lug (D) onto the
left axle. Ensure the latch closes.
12. Secure the latch with hairpin (B) ensuring the open end
of the pin faces the rear of the windrower.
NOTE:
The hairpin can become dislodged by crop if
installed with the open end facing the cutterbar.
IMPORTANT:
Check that wheels are locked and that handle is
in locked position.
13. Complete the conversion by ensuring the left side (A)
and right side (B) wheels are in the position shown.
3.15.4 Converting from Field to Transport Position
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
Moving Front (Left) Wheels into Transport Position
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
147725
OPERATION
Figure 3.83: Rear Axles
Figure 3.84: Field Position
95
Revision A