MacDon D65 Operator's Manual page 192

5. Remove fasteners (A) and tube connectors (B) at the
draper joint to uncouple the draper.
6. Pull the draper off the drive roller.
7. Line up the setscrews with the hole (A) in the guard.
Remove the two setscrews that hold the motor onto
the drive roller.
NOTE:
The setscrews are a 1/4 turn apart.
8. Remove the four bolts (B) that hold motor to the drive
roller arm.
NOTE:
Plastic shield (C) may require removal to gain access
to the top bolt.
9. Remove bolt (A) that secures the other end of the drive
roller (B) to the support arm.
10. Remove the drive roller (B).
Replacing Draper Drive Roller Bearing
1. Remove the draper idler roller assembly. Refer to
147725
MAINTENANCE AND SERVICING
Figure 5.122: Draper Connector
Figure 5.123: Drive Roller
Figure 5.124: Drive Roller
Removing Draper Drive Roller, page
178
177.
Revision A