MacDon D65 Operator's Manual page 146

1. To adjust guard tips upward, position tool as shown,
and pull up.
2. To adjust tips downward, position tool as shown and
push down.
TIP:
If trouble is encountered cutting tangled or
fine-stemmed material, install a knife hold-down
on every guard and then replace lower guards
with stub guards.
3. If material is tough to cut, install stub guards with top
guard and adjuster plate. A kit is available from your
MacDon Dealer. Refer to
Kit, page 231.
147725
MAINTENANCE AND SERVICING
6.2.3 Stub Guard Conversion
Figure 5.24: Upward Adjustment
Figure 5.25: Downward Adjustment
132
Revision A