MacDon D65 Operator's Manual page 222

5. Move endshields (A) away from tine tube and rotate
support (B) towards reel to remove it.
6. Insert tabs of new support (B) into slots in endshields
and rotate into endshields.
both endshields.
7. Secure support (B) to disc with bolt (C) and nut. Do
not tighten.
8. Secure endshields (A) to support (B) with bolt (C) and
nut. Do not tighten.
9. Reattach supports with bolts (C) and nuts.
10. Check clearance between tine tube and endshield
support, and adjust if necessary.
11. Torque nuts to 20 ft·lbf (27 N·m).
147725
MAINTENANCE AND SERVICING
Ensure tabs engage
208
Figure 5.194: Endshield Supports
Revision A