MacDon D65 Operator's Manual page 78

Reposition the left reel arm cylinder as follows:
NOTE:
Reel components not shown in illustration for
improved clarity.
1. Remove pin (A) securing cylinder (B) to bracket/light
assembly (C).
2. Remove bolts (D) securing bracket/light assembly (C)
to the reel arm, and remove the bracket/light assembly.
3. Remove the cable tie securing the harness to the
bracket/light assembly (C) or reel arm if necessary.
4. Swivel the light to the working position as shown.
5. Reposition the bracket/light assembly (C) on the
reel arm as shown, and secure with four bolts (D)
Tighten bolts.
6. Push the reel back and attach cylinder (B) to the
bracket/light assembly (C) with pin (A). Secure pin
with cotter pin.
7. Secure the light
assembly (C) using a cable tie.
8. Check the reel clearance to the backsheet, upper cross
auger (if installed), and reel braces.
9. Adjust the reel tine pitch if necessary. Refer to
Reel Tine Pitch, page
147725
harness to the bracket/light
65.
OPERATION
Figure 3.40: Forward Position
3.7.10
Figure 3.41: Rearward Position
64
Revision A