MacDon D65 Operator's Manual page 210

7. At the tail end, remove reel endshields and endshield
support (C) at applicable tine tube location.
NOTE:
There are no endshields on the center discs.
8. At the tail and center discs, remove bolts (A) securing
arm (B) to disc.
9. At the tine tube support (if installed) locations, either
release the bushing clamps or disconnect the support
channels from the tube support, depending on which
tine tube is being moved. Three tine tubes (B) require
that the channels be disconnected and two (C) require
only to remove the bushing clamp.
10. Remove bolt (A) at cam linkage so that tine tube (B) is
free to rotate.
147725
MAINTENANCE AND SERVICING
Figure 5.162: Tail End
Figure 5.163: Tine Tube Supports
Figure 5.164: Cam End
196
Revision A