MacDon D65 Operator's Manual page 209

4. Release bushing clamps (A) using a small screwdriver
to separate the serrations. Pull clamp off tine tube.
5. Rotate arm (A) clear of disc and slide arm inboard off
bushing and remove bushing halves (B). If required,
remove the next tine or plastic finger, so the arm can
slide off the bushing. Refer to:
• Removing Plastic Fingers, page 192
• Removing Steel Tines, page 191
Cam End Bushings
NOTE:
Removing cam end bushings requires that the tine
tube be moved through the disc arms to expose
the bushing.
6. At the cam end, remove endshields and endshield
support (A) at applicable tine tube location on the
cam end.
147725
MAINTENANCE AND SERVICING
Figure 5.159: Bushing Clamp
Figure 5.160: Bushing
Figure 5.161: Cam End
195
Revision A