17. Tighten clamp (A) with modified channel lock pliers (B)
so that finger pressure will NOT move clamp.
IMPORTANT:
Over-tightening clamp may result in breakage.
18. At the center disc, install the bolts (A) securing arm (B)
to disc.
19. At the tail end, install reel arm (B) and endshield
support (C) at applicable tine tube location with
bolts (A). Reinstall endshields.
NOTE:
There are no endshields on the center discs.
147725
MAINTENANCE AND SERVICING
Figure 5.181: Clamp
Figure 5.182: Tail End
203
Revision A