Removing Crop Dividers Without Latch Option From Header - MacDon D65 Operator's Manual

3. Lift safety lever (A).
4. Hold onto crop divider (B), push lever (C) to open latch,
and lower crop divider.
5. Lift crop divider off endsheet and store as follows:
a. Insert pin (A) on crop divider into hole in endsheet
at location shown.
b. Lift crop divider and position lugs (B) on crop
divider into bracket on endsheet.
engage bracket.
6. Close or install endshields. Refer to
page 35.

Removing Crop Dividers without Latch Option from Header

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel, raise header, stop engine, remove key, and engage safety props. For instructions, refer to your
windrower operator's manual.
2. Open or remove endshields. Refer to
147725
OPERATION
Figure 3.48: Crop Divider
Ensure lugs
3.2.3 Endshields,
Figure 3.49: Stored Crop Divider
3.2.3 Endshields, page
68
35.
Revision A