MacDon D65 Operator's Manual page 234

4. Move the right-hand reel sideways to separate the reel
tube (A) from the U-joint (B).
5. Remove the drive chain (C).
6. Route the new chain (C) over the U-joint (B) and
position onto the sprockets.
7. Position the right-hand reel tube (A) against the
reel drive and engage the stub shaft into the U-joint
pilot hole.
8. Rotate the reel until the holes in end of the reel tube
and U-joint flange (B) line up.
®
#243 (or equivalent) to four 1/2 in.
9. Apply Loctite
bolts (A) and secure with lock washers.
10. Torque to 75–85 ft·lbf (102–115 N·m).
11. Remove the temporary reel support (A).
147725
MAINTENANCE AND SERVICING
Figure 5.222: Replacing Chain
Figure 5.223: U-Joint
Figure 5.224: Supporting Reel
220
Revision A