MacDon D65 Operator's Manual page 41

Guards and Hold-Downs
Guard: pointed / forged / double heat treated (DHT)
Hold-down: sheet metal / adjustment bolt
Guard: pointed / forged / case hardened (CH)
Hold-down: sheet metal / adjustment bolt
Guard: stub / forged bottom / forged top / adjustment plate
Guard: stub / forged bottom / sheet metal top / adjustment bolt
Guard: four point / no-choke design (two long points with tangs / two short points without tangs)
Guard Angle (Cutterbar on Ground)
Center-link retracted
Center-link retracted
Center-link extended
Center-link extended
Conveyor (Draper) and Decks
Draper width
Draper drive
Draper speed
Delivery opening width (center delivery) / variable by
shifting decks
Delivery opening height (under frame tube at 8 in.
cutting height)
PR15 Pick-Up Reel
Quantity of tine tubes
Center tube diameter
Finger tip radius
Effective reel diameter (via cam profile)
Finger length
Finger spacing (staggered on alternate bats)
Reel drive
Reel speed (auto-adjust from cab using ground speed index)
147725
PRODUCT OVERVIEW
15–25 ft.
30–40 ft.
15–25 ft.
30–40 ft.
15 ft.
20, 25, 30,
35, 40 ft.
Center-link
fully
retracted
Center-link
fully
extended
15 to 30 ft.
35 ft.
Factory set
Adjustment range
27
7.5 Degrees
2.5 Degrees
17.0 Degrees
12.0 Degrees
41-5/8 in. (1057 mm)
Hydraulic
0–742 fpm (225 m/min.)
60-5/8 – 69-11/16 in.
(1540–1770 mm)
67-1/8 – 76-11/16 in.
(1720–1950 mm)
37-5/8 in. (955 mm)
43-1/2 in. (1105 mm)
5, 6, or 9
8 in. (203 mm)
10 in. (254 mm)
31-1/2 in. (800 mm)
30-3/16 – 31-1/2 in.
(766–800 mm)
65 in. (1650 mm)
11 in. (290 mm)
6 in. (150 mm)
Hydraulic
0–85 rpm
O
F
O
F
O
F
O
F
O
F
S
S
S
S
S
S
S
S
S
S
S
S
S
Revision A