MacDon D65 Operator's Manual page 85

3. Remove crop divider from storage location by lifting
crop divider to disengage lugs (A) at lower end
and then lowering it slightly to disengage pin (B)
from endsheet.
4. Position crop divider as shown by inserting lugs (A) into
holes in endsheet.
5. Lift forward end of crop divider and install bolt (A) and
special stepped washer (B) (step towards divider).
Tighten bolt.
6. Pull at the tip of the crop divider and ensure there is
no lateral movement. If necessary, adjust bolts (A) to
tighten crop divider and eliminate lateral movement.
7. Close or install endshields. Refer to
page 35.
147725
OPERATION
Figure 3.54: Stored Crop Divider
Figure 3.55: Crop Divider
3.2.3 Endshields,
Figure 3.56: Crop Divider
71
Revision A