Removing Narrow Draper Deflectors - MacDon D65 Operator's Manual

Removing Narrow Draper Deflectors
To remove narrow draper deflectors, follow these steps:
NOTE:
Left-end removal is illustrated.
1. Raise reel fully and lower header to ground.
2. Shift decks to allow work space at one end of header, if hydraulic deck shift installed. Otherwise, move decks
manually after shutting down windrower.
WARNING
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under machine for any reason.
3. Stop engine, remove key, and engage reel safety props.
4. Open endshield.
5. Remove the two Torx
6. Remove the three carriage bolts (B) and lock nuts, and
remove aft deflector (C).
7. Remove the four screws (A) and remove deflector (B).
8. Repeat above steps for opposite end.
147725
MAINTENANCE AND SERVICING
®
head screws (A) and lock nuts.
Figure 5.137: Aft Deflector
Figure 5.138: Forward Deflector
184
Revision A