MacDon D65 Operator's Manual page 108

2. Remove pin (A) and store at location (B).
3. Pull handle (C) upwards to release.
4. Lift the wheel to the desired height and engage the
support channel into slot (D) in the vertical support.
5. Push down on handle (C) to lock.
6. Pull the pin (A) on brace (B) on the left-hand wheel in
front of the cutterbar. Disengage the brace from the
cutterbar and lower the brace against the axle (C).
7. Remove pin (D), lower support (E) onto axle, and
reinsert pin into support.
8. Swing the axle (C) clockwise towards the rear of
the header.
147725
OPERATION
Figure 3.81: Rear Wheel – Left Side
Figure 3.82: Right Rear Axle
94
Revision A