Installing Wide Draper Deflectors - MacDon D65 Operator's Manual

6. Remove fasteners securing deflector to endsheet.
Nuts (A) are accessible from endshield side. Nuts (B)
on uppermost fasteners are accessible from behind
the deflector (C).
7. Remove the deflector (C).
8. Remove bolts (A) and remove deflector support (B).
9. If support (B) will not be reinstalled, replace lower
bolt (B) that holds belt guide (C) on opposite side of
endsheet.
10. Repeat above steps for opposite end.
Installing Wide Draper Deflectors
To install draper deflector, follow these steps:
NOTE:
Left installation is illustrated.
1. Raise reel fully and lower header to ground.
2. Shift decks to allow work space at one end of header, if hydraulic deck shift is installed. Otherwise, move decks
manually after shutting down windrower.
WARNING
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under machine for any reason.
3. Stop engine, remove key, and engage reel safety props.
4. Open endshield.
147725
MAINTENANCE AND SERVICING
Figure 5.132: Wide Deflector
Figure 5.133: Deflector Support
182
Revision A