Repositioning Fore-Aft Cylinders On Single Reel - MacDon D65 Operator's Manual

Repositioning Fore-Aft Cylinders on Single Reel

The reel can be moved approximately 9 in. (227 mm) further aft by repositioning the fore-aft cylinders on
the reel arms.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
Reposition the right reel arm cylinder as follows:
NOTE:
Reel components not shown in illustration for
improved clarity.
1. Position reel fully aft with support arms horizontal.
2. Stop the engine and remove the key from the ignition.
3. Remove the four bolts (A) securing the cylinder
bracket (B) to the reel arm.
4. Push/pull the reel until bracket (B) lines up with the
fore/aft set of holes (C).
5. Reinstall the four bolts (A) securing the cylinder
bracket (B) to the reel arm at the new position.
147725
OPERATION
Figure 3.32: Right Arm Cylinder – Forward
Position
Figure 3.33: Right Arm Cylinder – Rearward
Position
60
Revision A