Replacing Double Reel U-Joint; Removing Double Reel U-Joint - MacDon D65 Operator's Manual

4. Install the drive chain (A) onto the drive sprocket (B).
5. Tighten the drive chain, refer to
page 212.

5.9.4 Replacing Double Reel U-Joint

The double reel drive U-joint allows each reel to move independently from the other.
Lubricate the U-joint according to the specifications. Refer to
Replace the U-joint if severely worn or damaged. Refer to

Removing Double Reel U-Joint

1. Remove the drive cover, refer to
Cover, page 209.
2. Support the inboard end of the right reel with a front end
loader and nylon slings (A) (or equivalent lifting device).
IMPORTANT:
Avoid damaging or denting the center tube by
supporting the reel as close to the end disc
as possible.
147725
MAINTENANCE AND SERVICING
Tightening Drive Chain,
Removing Double Reel U-Joint, page
Removing Drive
215
Figure 5.210: Reel Drive
5.3.6 Lubrication and Servicing, page
Figure 5.211: Reel and Reel Support
118.
215.
Revision A