MacDon D65 Operator's Manual page 66

3. Support the wheel weight by lifting slightly with one
hand on handle (B), and pull up on the handle (A) to
release the lock.
4. Lift the wheel using handle (B), and engage the support
channel into the center slot (C) in the upper support.
5. Push down on the handle (A) to lock.
6. Lower the header to the desired cutting height using
the windrower controls and check the load indicator.
IMPORTANT:
Continuous operation with excessive spring
compression (i.e., load indicator reading greater
than '4' or a compressed length less than
11-5/8 in. [295 mm]) (A) can result in damage to the
suspension system.
7. Adjust the header angle to the desired working angle
with the machine's header angle controls. If header
angle is not critical, set it to mid-position.
8. Use the windrower cab display module (CDM) controls
to automatically maintain cutting height. Refer to your
windrower operator's manual for details.
147725
OPERATION
Figure 3.23: Stabilizer Wheel
Figure 3.24: Load Indicator
Figure 3.25: Spring Compression
52
Revision A