MacDon D65 Operator's Manual page 211

11. Release bushing clamps (A) at the cam disc with a
small screwdriver to separate the serrations. Move
clamps off bushings.
12. Slide tine tube (A) outboard to expose the bushing.
Remove the bushing halves (B). If required, remove
the next tine or plastic finger, so the arm can slide off
the bushing. Refer to:
• Removing Plastic Fingers, page 192
• Removing Steel Tines, page 191
Tine Tube Bushings (If Installed)
If the tine tube reinforcing kit is installed:
13. Locate the support (A) that requires a new bushing.
14. Remove four bolts (B) securing channels (C) to
support (A).
15. If finger (D) is too close to support (A), to allow access
to bushing, remove screw (E) and finger (D). For
instructions, refer to
192.
147725
MAINTENANCE AND SERVICING
Removing Plastic Fingers, page
Figure 5.165: Bushing Clamp
Figure 5.166: Cam End
Figure 5.167: Tine Tube Support
197
Revision A