MacDon D65 Operator's Manual page 194

Installing Draper Drive Roller
1. Position the drive roller (B) between the roller
support arms.
2. Install bolt (A) that holds the drive roller to the arm
closest to the cutterbar.
(95 N·m).
3. Grease motor shaft and insert into the end of the
drive roller.
4. Secure motor to the roller support with four bolts (A).
Torque to 20 ft·lbf (27 N·m).
NOTE:
Tighten any loosened bolts and reinstall plastic
shield (B), if removed.
5. Tighten the two setscrews through access hole (C).
6. Wrap the draper over the drive roller and attach ends of
draper with tube connectors (B), screws (A), and nuts.
NOTE:
Head of screws must face the center opening.
147725
MAINTENANCE AND SERVICING
Torque bolt to 70 ft·lbf
180
Figure 5.127: Drive Roller
Figure 5.128: Drive Roller
Figure 5.129: Draper Connector
Revision A