Manually Correcting A Calibration - Waters Autospec Premier Operator's Manual

Calibration report window

Manually correcting a calibration

Caution:
Calibration Parameters dialog box with the "Perform auto peak
matching option" selected, the spectrum is automatically recalibrated;
any manual corrections are lost.
See "Editing the calibration parameters" on page
Sometimes you must manually adjust some of the matched peaks during the
calibration process. These mismatched peaks are usually apparent by the
larger-than-normal residual errors they leave. For example, in the following
figure, there are two mismatched peaks with larger residuals (highlighted).
If you manually correct a calibration but open and close the
5-9.
Manually correcting a calibration 5-7