Verifying The Instrument's State Of Readiness; Monitoring The Mass Spectrometer Leds; Tuning And Calibration Information - Waters Xevo TQ-S Operator's, Overview And Maintenance Manual

10. Click Resolve
Result:
IntelliStart software displays "Ready" in the Instrument Console.
If clicking Resolve fails to put the instrument in Operate mode,
Tip:
IntelliStart software displays corrective actions in the instrument
console.

Verifying the instrument's state of readiness

When the mass spectrometer is in good operating condition, the power and
Operate LEDs show constant green. You can view any error messages in
IntelliStart software.

Monitoring the mass spectrometer LEDs

Light-emitting diodes on the mass spectrometer indicate its operational
status.
Power LED
The power LED, to the top, left-hand side of the mass spectrometer's front
panel, indicates when the mass spectrometer is powered-on or powered-off.
Operate LED
The Operate LED, on the right-hand side of the power LED, indicates the
operating condition.
See the mass spectrometer's online Help topic "Monitoring the mass
spectrometer LEDs" for details on the Operate LED indications.

Tuning and calibration information

You must tune and, if necessary, calibrate the mass spectrometer prior to use.
You can perform these tasks using IntelliStart software.
For further instruction, see the mass spectrometer's online Help topic
"Instrument Setup".
2-4 Preparing the Mass Spectrometer for Operation
or Operate
When the mass spectrometer is in good operating condition,
.